Type SAM - Manual stellite® tipping machine

Deciding features

• Well-proven stellite® tipping system with excellent reputation.
• The stellite® is welded on the saw by a resistance welding method.
• The structural condition of the stellite® does not change during welding. Cracks and holes in the stellite® are thus avoided.
• The stellite® is welded horizontally and the tip size can be adjusted in width.
• The stellite® bar is manually advanced and is cut off by a cutting off wheel after welding.
• Pre-shaped (prism) stellite® P 5,0 and P 6,5 and round stellite® from 3,2 to 8,0 mm dia can be used.
• No need for elaborate saw preparation and grinding of the saw tip before tipping.
• New tips can be directly welded onto existing tips.

• Easy adjustments allow band, circular and gang saw blades to be tipped on the same machine.
• Tipping of the saws is manually executed. Annealing is carried out automatically in a second process.
• The simple construction of the machine eliminates the need of expert operation.
• The central height adjusting device gives hassle free installation of the saw blade.
• The working speed of the machine is up to 12 teeth per minute.

• Carrousel centrally adjustable in height for right-running band saw blades.
• Single stands for heavy or left-running band saw blades.
• Additional supports for double-toothed band saw blades.
• Equipment for circular saw blades with centering devices for bores dia. form 22 to 210 mm.
• Equipment for gang saw blades for widths from 80 to 160 mm.

• Blade thickness: 0,8 to 4,0 mm
• Tooth pitch: 13 to 115 mm
• Tooth height: 5 to 40 mm
• Front rake angle: 10 to 30°

• Blade width: 80 to 300 mm
• Blade length: to partir 5500 mm
• Narrow band saws: 25 to 80 mm

• Outside diameter: 250 to 1000 mm
• Bore diameter: 22 to 210 mm

• Blade width: 80 to 160 mm
• Blade length: unlimited
• Feeding speed: 12 teeth/min
• Round Stellite®: Ø 3,2/4,0/5,0/6,4/8,0 mm
• Preformed Stellite® (Prism): P 5,0 mm/P 6,5 mm
• Cutting wheel: 115 / 1 x 22 mm 
• Connected load: 25 Amp.
• Weight of machine: 250 kg, without support
• Height of the machine: 150 cm
• Volume Sea-case approx.: 2 m3 approx.
• Special executions on request.
• Subject to alteration in design for technical improvements. 

• completely new stellite tipping system : the stellite material is well welded on the saw by resistance welding method. 
• the structural features of the stellite does not change during welding operation. 
• rounded and pre-shaped (prism) can be used. 
• no complicated preparation of the saw is required. 
• new tips can be directly welded onto existing tips. 
• circular saw is also well tipped. 
• very easy to handle, no expert operator is required. 
• the annealing process is automatic.